In CrossWorks 1.7 there are Target interfaces for Olimex JTAGs, note that RTCK is not used with a FT2232 design so your JTAG clock should not exceed 1/6 of your target MCU clock or the JTAG will lock up. Right click on the new target interface and select "Properties" - set the following properties:.Right click on a blank space in the targets window and select "New Target Interface > Generic FT2232 Device".There is profile for ARM-USB-TINY in CrossWorks, but if you want to use "Generic FTD2232" target interface you have to do as follows: The FTDI drivers can be downloaded from the following address: How to install ARM-USB-TINY to work with CrossWorks:.Olimex OpenOCD debuggers have JTAG by default. You would need an addiitonal adapter – ARM-JTAG-SWD. The board can be programmed only via SWD (Serial Wire Debug) interface. LPC1227 lacks JTAG according to the microcontroller's datasheet.I have LPC1227 board and can't program it with your OpenOCD debugger.FTDI provide drivers and instructions at their web site, download them and use our ARM-USB-TINY-H PID: 0x002a, VID: 0x15BA to install the drivers.It has FTDI drivers, how should I alter them to work with my installation? I am currently using operating system X.IAR EW has support for GDB and works with ARM-USB-TINY-H.
0 kommentar(er)
